Broken Lower Screw Post Repair
Let's assume that both posts are broken or cracked. The effect of this cracking is that the screws do not do their job. Usually, using longer screws may help, but this typically is short lived since the cracks will continue downwards. Once the pressure between both halves is softened, the calculator doesn't work anymore. The solution is to repair the broken posts.
Old methods to repair broken post is to glue them (but this doesn't hold together too long) and to tie them down with very small gauge copper cable, applying pressure so that it holds together. This may solve some cases, but not when the screw path has been destroyed - maybe due to strong tightening of the screws.
Other repair methods have been proposed, including drilling down the screw and placing in its place a cylinder with screw path, glued in place. We tried this method but there was a problem: the torque used to screw resulted in cracked glue and the cylinder separating from the substrate - every time.
Our method was devised with three goals in mind:
The piece that we have designed requires drilling the old posts to the keyboard ciruit level, taking care of leaving the hole clear. The design on the piece is such that the pin will be glued to the inner part of the rest of the screw post; and the surface of the piece can be glued to the keyboard circuit, so that the torque on the substrate is avoided (it also helps that torque is also resisted by the other post, when using the full piece)
When gluing the piece, there are several precautions that need to be taken:
We recommend to repair both posts at the same time. However, if you are confident on the resistence of the other post, you can cut the piece in two. As it is symmetrical, it can be used for both posts, just twisting it 180º. Using the full piece, the other post side does not need to be glued - the torque resistence is done by the post itself over a much longer distance.
N.º de producto: Lower Post Repair Kit
Conjunto de puiezas para la reparación de los postes de abajo de la serie de calculadoras 41c, 41cv y 41cx full nut, incluyendo conextores cebra, recambio de postes y soporte para apoyar las pinzas y proteger el teclado.
Precio anterior 70,00 €
Nuevo Soporte zebraN.º de producto: zebraholder
Zebra Holder to keep the elastomeric zebra connectors in the contacts between main board and processor circuit in the HP41c calculator family, full nut versions.
N.º de producto: lowerscrewblack
Dos tornillos largos para los postes inferiores de la calculadora HP41C - black