Pieza para reparación de parte trasera de HP41c

N.º de producto: brokenback

En existencias

14,00
El precio incluye el IVA
Reducciones de precio

Formas de entrega posibles: Carta, Modules to Overseas, Insured overseas shipment

Evaluaciones de clientes para Pieza para reparación de parte trasera de HP41c

Número de evaluaciones: 5
Evaluación media: 4,8
Leer todas las evaluaciones
surprisingly simple and effective repair of back case
de el 07/09/2020
It frees the rear half of the housing from the contact pressure that has to be generated with the screws, while it directly presses the part with the battery and bus contacts firmly against the printed circuit board.
Worked like a charm
de el 03/02/2020
I had two broken screw holes on my 41CX halfnut, and ordered the repair kit for a more permanent fix. Rather than glue, I used JB Weld Plastic Bonder, a two-part expoxy meant for plastics, and applied a thin coating to the whole mating surface of the repair piece. With a couple of small binder clips to clamp the piece in place, the set was strong enough after a couple of hours to carefully reassemble the calculator (and then handle very carefully for the remainder of the 24-hour cure time). I don't intend to do any drop testing, but the case now feels perfectly solid for everyday use, and much sturdier than my attempt to epoxy the original screw holes back into place.
Good, but needs a little careful preparation.
de el 22/02/2019
A nicely designed piece, printed well. On balance, it does the job. I've bought two parts, for two different 41C's of slightly different vintage.

Slight problems, though - when fitted squarely in position according to the instructions, the screw holes are slightly off position on the case. The tie-bar between the two screw blocks is about 0.5mm too long, and the blocks need a little careful sanding to bring them closer in towards the centre line of the case. Doing this positions the holes correctly horizontally, but not vertically. Setting the correct vertical position for the holes (along the line of the case centre line) then leaves the horizontal line of the blocks out-of-place, so a little filing of the outer horizontal edges of the blocks is also required to allow the module contact block to correctly fit into place.

With a little bit of design refinement this item would get 5* from me, but in any case is a clever solution for the repair of the case bottom.

Excellent, recommended - but take your time with preparation before gluing.
Leer todas las evaluaciones

Accesorios

Producto Nota Estado Precio
Módulo conector de baterías y puertos de expansión de HP-41c/cv/cx Módulo conector de baterías y puertos de expansión de HP-41c/cv/cx
55,00 € * Notificar sobre disponibilidad
Kit de reparación para conector de baterías y puertos de expansión de las HP-41c/cv/cx Kit de reparación para conector de baterías y puertos de expansión de las HP-41c/cv/cx
26,00 € *
Soporte zebra Soporte zebra
12,00 € *
4 x Pieza para reparación de parte trasera de HP41c 4 x Pieza para reparación de parte trasera de HP41c
50,00 € *
* Los precios incluyen el IVA
Mostrar detalles del accesorio

Los clientes que han comprado este producto también han comprado

Pies para HP41c - pack de cuatro
4,00 / 4 unidad(es) *
* Los precios incluyen el IVA

Examine también estas categorías: El Rincón de la HP41, Inicio, Accesorios, HP 41C Repair, Broken upper back case screw head supports